Stockwhip Build

Jyri Haveri · Post by **Jyri Haveri** » Fri 5. Jan 2018, 05:22

Looking good Ethan! Tighter is better as Bernie said. Well done!

Roy Partin · Post by **Roy Partin** » Fri 5. Jan 2018, 12:54

Very nice looking stockwhip Ethan. Hopefully the keepers will break in and relax a bit with some use

Sir Roger Tuson · Post by **Sir Roger Tuson** » Fri 5. Jan 2018, 13:48

Not bad at all, sir! Hopefully things should bed in nicely.

Ben Varsek · Post by **Ben Varsek** » Fri 5. Jan 2018, 15:35

Very good work, Ethan!
How does it crack?

All the best
Ben

Ethan Mitchell · Post by **Ethan Mitchell** » Sat 6. Jan 2018, 23:35

Rachel McCollough · Post by **Rachel McCollough** » Sun 7. Jan 2018, 00:12

Very nice, very nice!!!

Robert Gage · Post by **Robert Gage** » Sun 7. Jan 2018, 00:13

Very nice, Ethan!

You might try using a little less force and speed, and see if the whip still does what you want....

Ron May · Post by **Ron May** » Sun 7. Jan 2018, 02:03

You did a good job.
It rolls out nicely and flows smoothly.
Be proud.

Ron

Ethan Mitchell · Post by **Ethan Mitchell** » Sun 7. Jan 2018, 03:06

Thanks!

Robert,
I will, still getting used to how light it is.

Mark Elliott · Post by **Mark Elliott** » Sun 7. Jan 2018, 03:29

Nice work, Ethan

Jyri Haveri · Post by **Jyri Haveri** » Sun 7. Jan 2018, 09:09

Well done Ethan!

Robert Gage · Post by **Robert Gage** » Sun 7. Jan 2018, 09:54

Ethan, I thought it must be very light from the way you cracked it....

Sir Roger Tuson · Post by **Sir Roger Tuson** » Sun 7. Jan 2018, 10:36

Very smooth Ethan. Nice work.

Ben Varsek · Post by **Ben Varsek** » Mon 8. Jan 2018, 17:21

Very good work, Ethan!

All the best
Ben

Ethan Mitchell · Post by **Ethan Mitchell** » Mon 8. Jan 2018, 20:42

Thanks Ben!

Here are a few pictures of the finished stockwhip:

Ethan Mitchell · Post by **Ethan Mitchell** » Mon 8. Jan 2018, 20:48

I have another fiberglass rod from Roy so I want to have another go at that stubborn old keeper sometime.

Jyri Haveri · Post by **Jyri Haveri** » Mon 8. Jan 2018, 20:55

Well done! It looks reeeeally good!

Robert Gage · Post by **Robert Gage** » Mon 8. Jan 2018, 21:06

Ethan, this looks very professional! Well done!

Ron May · Post by **Ron May** » Mon 8. Jan 2018, 21:07

Nicely done Ethan.

Ron

Ethan Mitchell · Post by **Ethan Mitchell** » Mon 8. Jan 2018, 21:26

Thanks very much guys!

Whip Basics. The Forum